| •
USB
to serial--Keyspan 19HS or RadioShack 26-183 (no belkin) |
| •
Do
not use MS XPMedia 2002 OS |
| •
Firmware
V29 for interface (anything older than v29 must have IC chip
installed) |
| •
When
sent an update for read/write utility it will come as a "zip" file...double
click on it, when the WinZip screen comes up highlight the files(s) and click
"extract to" the default address: C:\Program Files\Ultra\PCM (unless
it's been saved to a different folder) If you don't have a WinZip program you
can down-load an "evaluation version" free at: |
|
| Unzip
this file to your desktop and double-click on the set-up icon, it willautomatically
set up your directory and place an UltraPower icon on your desktop. |
| Some
notes on using the programmer: |
| •
USB
to serial--Keyspan 19HS or RadioShack 26-183 (no belkin) |
| •
Do
not use MS XPMedia 2002 OS |
| •
On
'03 and newer Workhorse you need to pull fuse #21 (usually under the dash.sometimes
under a panel on top of the dash) this fuse disables the instrument cluster. |
| •
On
other vehicles with digital clusters you must disable IPC/DIC, INFO, SEO Ign. |
| •
You
can tune '96-'09 non CAN BUS gm vehicles: 4.3L, 4.8L, 5.0L, 5.3L, 5.7L, 6.0L,
6.6L, 7.4L, 8.1L |
| •
For
more info read the information contained in the "Help" screen after
you open the programmer. |
| •
To
check proper communication go to "Tools" and "Vehicle Info"
you should receive a screen that gives you the VIN and calibration ID's. |
•
Click
on "Read" and follow the prompts, name your read file and save to a
folder
that you can create (you can set up a "Default Path"
so it will automatically go there)--it takes 10-15 minutes. |
| •
Create
an email to tech@brazelsrv.com and attach the file. |
| •
We
will send back a tuned file with the same file name you gave it, we will add a
date to the end of your file name. |
| •
Go
to "Tools" and "Vehicle Info" to check communication. |
| •
Click
on "Program" and follow the prompts--it should program in about 3-4
minutes. |
| •
If
you have any questions, call or email. |
| |
UFO
Chassis |
| •
Disconnect
plug to the back of the cluster (2 plugs in center--the one closest the drivers
window) |
Winnebago
w/CCC |
| •
Winnebago
w/CCC computers-located in drivers side rear cargo door--remove upper and lower
panels--pcm, tcm, ccm, wabco--fuse box for pcm power, etc located there as well. |
| •
Fuse
box also located in drivers side front cargo door--remove panel to access. |
